Analyze The Reason Why The Belt Conveyor Often Runs Off?
Nov 17, 2020
Misalignment is a common fault during the operation of belt conveyors. Long-term misalignment not only severely wears the edges of the tape, but also causes sudden accidents such as tape tearing and scratching. This article shares five adjustment methods for belt conveyor belt deviation.
According to the production practice experience, some rules of tape deviation are summarized as follows:
(1) Running tight and not loose: During the transportation of the belt conveyor, if the center lines of the front and rear rollers are not parallel, resulting in different tightness on both sides of the tape, the tape will run off the tight side;
(3) After running but not before running: the roller is not on the section perpendicular to the running direction of the tape, but one end is in front and the other end is behind (depending on the running direction of the tape), the tape will deviate to the rear end;
(2) Running high instead of running low: The supporting roller is not at the same horizontal position parallel to the running direction of the tape, but one end is high and the other is low, and the tape will run off the higher end.
1. Gravity adjustment method
If the belt runs off under a heavy load, the roller and the support roller bracket of the belt can be properly increased, so that the weight of the material on the tape produces a component of force that prevents the tape from running away, until the tape returns to the normal position.
2. The method of adjusting the deflection roller
When the belt conveyor's deviation range is not too large, the rule of "after running but not forward" of the belt can be used to automatically adjust the belt conveyor with a groove-shaped deviation adjusting roller. When the tape runs out of direction, it encounters the stop roller on the trough-shaped deflector roller, and moves forward in the running direction of the tape due to the friction between the stop roller and the edge of the tape, and the other side moves relatively backward. At this time, the tape moves toward the side of the back-turning stop roller until it returns to the normal position.
3. The height adjustment method
If the tape always deviates to a certain side when idling, use the rule of “running high but not low” with the tape to properly elevate the opposite side of the roller support. The front and rear elevating array is based on a pad roller. Accurate, slowly reduce the height of the pad, the tape deviation will disappear.
4. Vertical roll deviation adjustment method
If the tape always deviates to one side when running, the idler can be installed vertically (vertical roller) on the deviated side of the tape. In this way, on the one hand, the tape is forced to reset due to the force of the vertical roller; on the other hand, due to the vertical roller and the tape The friction of the edge reduces the linear velocity on the side of the tape, and relatively increases the linear velocity on the other side of the tape, causing the tape to move to the other side until reset.
5. Roller cleaning method
If the belt runs at a certain fixed point and is fixed, check whether the roller at this point has stalled, muddy, etc., which causes the roller diameter to change or the roller falls off, and take corresponding measures.






